Farmall & IHC Tractors Discussion Board |
Re: Farmall Super A--- Woods L-59 -- No enough mmmmph!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gene b on February 27, 2002 at 01:36:15 from (63.15.134.93):
In Reply to: Farmall Super A--- Woods L-59 -- No enough mmmmph! posted by Joey K. on February 26, 2002 at 13:41:14:
pto speed is 535 belt pulley is over twice that speed someone has placed pulley on the wrong shaft when you drive the mower off the pto shaft the pulley will be 18-20 in dia there is not room on the superA for this the pulley for the belt pulley is around 10in dia I sell these mowers as I get a tractors ready you need to go to a WOODS dealer and get the correct set-up as the spline is different from pto to the belt pulley
Follow Ups:
Home
| Forums
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|