|
Farmall & IHC Tractors Discussion Board |
Re: brake problem and free wheeling when going down hills
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ace Schrunk on March 03, 2002 at 08:58:24 from (67.233.139.234):
In Reply to: brake problem and free wheeling when going down hills posted by jerry on March 02, 2002 at 20:59:52:
Sounds like the pump is ok if you can get 1500 psi on steering, so I would say go through the MCV housing on the left side sounds like you are not getting good flow or pressure to TA clutchs and brakes, make sure the little dump valve is not sticking. I would also clean the brakes you should have as good a brakes with out power, make sure the self adjusting screws are free to turn and the stop on the screw is holding the screw from turning backward, should be able to move the screw without the stop clip in place just by pushing on it with finger, if that is ok you may have to look at the master cylinder.
Follow Ups:
Home
| Forums
Today's Featured Article -
Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
