Farmall & IHC Tractors Discussion Board |
Re: 1206 engine and power
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steven@nd on April 01, 2002 at 18:55:48 from (12.23.184.197):
In Reply to: 1206 engine and power posted by Sidney on April 01, 2002 at 17:58:25:
The 1206 is NOT a turbo'd 806. I quote from Ken Updike's book "International Harvester Tractors 1955-1985": "During testing and development of the 1206, threee major challenges developed. First, an engine capable of delivering 100+ horsepower had to be built. Working together with engineers from the SOLAR division of IH, designers retooled the D-361 engine (used in the 806) for heavy-duty turbocharged duty. Second, the power train needed to be beefed up to handle the extra horsepower from the turbo. The engineers at Hinsdale designed an all-new heavy duty power train using specially hardened gears, heavier pinions and final drive gears (1/2 inch wider than those of the 806), a wider PTO drive gear, and bearings that could reliably deliver 98 horsepower to the drawbar... The tires used on the tractors of the day did not even begin to hold up. The 1206 had major tire sidewall buckling -- and even failure -- with conventional tractor tires. Some tires spun off the rim during testing... IH workde withmajor tire manufacturers for over two years to develop a completely new kind of tire that could put the 1206's power to the ground. This was the 18.4-38 heavy duty tire, designed to have the casing, lug strength, and wear that could stand up to the 1206... The DT361 was not just a turbocharged 806 engine. Instead, IH engineers built the 1206 specifically for turbo power right from the start. Using twinjet oil-cooled pistons, a bigger 10-inch dry-type air cleaner (with dual elements), an increased capacity radiator, a bigger fan, and a larger engine oil cooler, the 1206 was built from the start to handle a turbo... The "Elotherm"-hardened crankshaft used seven main bearings for added strength and featured up to 100 percent stronger construction for longer wear and more strength..." Hope this explains it better for you. And a pic of a 1206 Wheatland to get you drooling...
![third party image](http://members.tccoa.com/smgussey/antique/1206-1.jpg) Steven
Follow Ups:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|