Farmall & IHC Tractors Discussion Board |
Farmall M steering and hydraulic system
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Luke on April 21, 2002 at 19:13:16 from (208.23.78.97):
I have a 48 M the steering wiggles so much in road gear I go from ditch to ditch without moving the wheel. I need some suggestions on the best way to tear apart the front end, and what to look for and replace? I also have a Behlen power steering system on this tractor and the extra hyd. pump on the engine sets the ignition system back to far and the previous owner removed the oil filter and housing to make it fit. I need a seal kit for the power steering because it leaks like a sieve, but I have no clue where to start looking for that. Or would I be better to just take it off? I also need to know how to set my tractor back up with the original liftall to run my add on three point? If yall could help i would appreciate it
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|