Farmall & IHC Tractors Discussion Board |
Re: No Load Miss on M, please help...Runs great with a load.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Charlie on May 13, 2002 at 16:04:47 from (209.130.133.185):
In Reply to: No Load Miss on M, please help...Runs great with a load. posted by Mr. J on May 12, 2002 at 22:48:58:
My M did the same thing last fall plowing - ran great with the plow in the ground, ran like crap with the plow raised. Got it back to the house and started looking at the manifold. One side was missing a stud, another was stripped - resulted in the gasket on that side being completely gone. Fixed the studs, put on new gaskets and it ran great. Try pulling the choke out part way when your tractor is running bad. It it makes it run better but starts to smoke I would definitely look at the manifold.
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|