Farmall & IHC Tractors Discussion Board |
Bull/pinion on 39 H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Obie nh on May 28, 2002 at 10:51:12 from (64.12.105.163):
I AM trying to get out the bull pinion gears to replace some seals and bearings.WITH SOME HELP FROM YOU GUYS GOT THE tranny cover off.Thanks took care of one problem now have another.Took the cap screws out of the bull gear and it looks like the axle has to slide out to let the gear off the shaft.The book says take out the 4 axle retaining bolts which I thought were the 4 on the far outside end of the axle.removed these only to find that did nothing!The 4 bolts they are talking about are they the 4 bolts on the inside of gear which look like they are diffecult to impossible to get out.Any and all help would be great.Thanks Guys!!!!!!!
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|