Farmall & IHC Tractors Discussion Board |
Magneto vs Distributor for Farmall H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Y. Canby on June 10, 2002 at 19:46:30 from (216.158.80.49):
Hello, I wanted to ask as to whether it is more relable to keep the magneto on my H or switch it over to a distributor. Right now the recently overhauled H runs well with its Mag until it gets pretty warm and then it will start to miss, slowly at first and then to the point where it will barely run. It only does this when under constant load in hot whether such as raking hay. I think the coil on the mag may be weak. I can get a new one for $50. The tractor originally had no electricity on it but I put on a 12 volt system so it could power a distributor if needed. I would like to keep her as original as possible but I want her to be usable on our farm as well. Any thoughts on this ? Thanks for your help. YC
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|