|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: How easy to roll over on a narrow front M?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Diesel Don on June 18, 2002 at 05:02:35 from (141.129.1.114):
In Reply to: Re: Re: Re: How easy to roll over on a narrow front M? posted by The MATH Analysis on June 17, 2002 at 18:26:27:
I had some fork lift operator's training where I work and there is an easy analogy we were shown to determine a roll over situation.If you look at the rear axle of a forklift you will find they are set up quite similar to a WFE tractor.What determines the roll over point is the PIVOT POINT of the axle,which happens to be in the center.If lines are drawn from the pivot to the rear wheels,a triangle is formed.If the center of gravity of the machine shifts outside of that triangle,the machine WILL roll over.The best roll protection is avoiding sidehill operation,reduction of speed when turning corners,and,if loaders are being used,always keep the load as close to the ground as possible.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I’m handing him tools and he says, "give me that..." and I’ve already got it in his hand or "hand me that....."and I’ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
