Farmall & IHC Tractors Discussion Board |
starter drive or ring gear?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by David in Missouri on August 14, 2002 at 08:31:33 from (216.41.148.190):
I have been putting together an "45 B. I found it setting in the brush. Head off, oil pan off, tires rotted off, motor stuck, you name it, it was in bad shape. I went thru the starter. It turns over like a champ. When I bolted it on the motor it acts like the ring gear is bad. I can roll the engine over about 1/4 turn and sometimes it will kick in. That is what makes me think it is the ring gear. My question is how can I make sure that it is not my starter drive. the bendix looks OK and it runs out like it should when it is off the tractor. I just don't want to spend money I don't need to spend. I have already spent way too much money on this "project". Any suggestions?????
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|