|
Farmall & IHC Tractors Discussion Board |
Re: starter drive or ring gear?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kendall on August 14, 2002 at 12:03:12 from (64.209.33.251):
In Reply to: starter drive or ring gear? posted by David in Missouri on August 14, 2002 at 08:31:33:
My Super-A once acted like you're describing. I put new brushes in it, cleaned the armature, and now it spins at one million RPM! If you have to replace anything, do both the ring gear and starter drive. If one is bad, it will wear out the other. Don't use sandpaper to clean the armature. Bits of sand will get imbedded in the copper. Use emery cloth. And by the way, the money will keep going out. Grin and bear it. (just keep the wife from finding out just how much its costing!)
Follow Ups:
Home
| Forums
Today's Featured Article -
The Day Tractor Lovers Dream About - by Angus Crawford. The day started at five o'clock on the morning of Friday, the January 29, 1999. My father, my sister, my uncle, my cousin and myself all climbed into my uncle's Toyota van. It was six thirty in the morning and we had a long day ahead. We traveled for six and a half hours to our destination - a little country town with a population of no more then one hundred and fifty people (57 of them being children under the age of thirteen). We arrived hoping to meet up with a man we knew had over one
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
