Farmall & IHC Tractors Discussion Board |
H bolster rebuilt, some play present
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Carey on August 27, 2002 at 19:26:24 from (209.246.134.121):
just rebuilt the bolster assy. on the sup H. Replaced all bushings, seals and bearings. Kept the sector and the worm shaft. Alot of play was taken out of the steering but some is left between the worm and sector. I can grab ahold of the worm shaft and turn it 30 to 40 Degrees before the gears mesh and play is gone, but the same cond is present when turning back the other way. I walked over to the 130 to see how much play is present with it..NONE, no noise, no play. I guess what Im trying to ask is should there be absolutly no play between these gears? My next step would be to get a new worm and sector but that would be about $350 new,and would I be happy with the results. If anyone has a full round or half sector and worm in good cond I might be interested.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|