|
Farmall & IHC Tractors Discussion Board |
Re: Re: C123 Block Boring
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Stan(VA). on August 29, 2002 at 05:06:23 from (208.59.156.179):
In Reply to: Re: C123 Block Boring posted by gene b on August 29, 2002 at 04:16:00:
Gene,
The 3 1/4" pistons already come with the thinner sleeves so there's no room to take any more off! If it helps, I allways thought all C123 blocks were the same as far as sleeve openings, but found that on these later motors IH went back to the smaller opening like in the C113 block and just sent them from the factory with the same overbore kit you would use in a C113. What I'm trying to do is more like fit a straight C's C113 block for the overbore sleeves that are for a Super C's C123 block.
Thanks,
Stan(VA).
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
