Farmall & IHC Tractors Discussion Board |
Re: 66 series
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RPM on September 06, 2002 at 06:19:31 from (63.110.182.225):
In Reply to: 66 series posted by RandyCKS on September 05, 2002 at 10:22:21:
766/1566 all started with the same basic castings and frame rails in diesels, this includes front bolster, clutch housing, rear frame, the parts that were hung on like engine in 766 was demensionally smaller than the rest of the 966 & up, hitchs were CAT II on 966 down, CAT III on 1066 up, however 1066 had a 2" shorter lift arm length and a lower main hydraulic relief PSI, also 15 had planetary axles on same rear frame casting that was originally made on the 806. I worked in parts at IH dealer for 34 years in the high times of the 60/70s, It gets a lot more complicated in details but thats a basic idea.
Follow Ups:
Home
| Forums
Today's Featured Article -
Check Your Coolant - by Bill Radford. Great tips on how and when to check the coolant in your tractor.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|