|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Super-Tractor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on September 10, 2002 at 18:00:56 from (64.228.13.52):
In Reply to: Re: Re: Re: Super-Tractor posted by CNKS on September 10, 2002 at 05:26:48:
Well Charles, Sven and Steven I think it went right over their heads.
Charles: I just looked these up in 150 Years of International Harvester by C H Wendel and you will love this. In the 1930s Harvester was marketing this machine on its benefits in preventing erosion. I think I will side with you on this one. Wendel also describes three plows being the moalboard, the disc plow and the item we believe guy on e-bay has, the harrow plow. It shows several pictures and yes they are very similar to Sven's Oliver in photo galery. Harvester built the last IH harrow plows in 1962. They came in 3, 4, 6 and 9 foot models and two of them could be hooked in tandem to double width of cut. They could also be equiped with seed box for one pass seeding of wheat. It further says that these harrow plows were not widely known as they were sold and used specificly in wheat growing areas. I have never seen one. For the benefit of anyone not familiar with these two disc plows. The disc plow has beams just like a moalboard plow and discs are about 24 to 26 inches in diameter and one disc is mounted to each plow beam, at an angle similar to moalboard. These have cutting widths much the same as moalboard plows. On the harrow plow the discs are put together in a gang just like a disc harrow, with a large arbor bolt going through discs. The discs are spaced 10 to 12 inches apart on gang. The gang is positioned much the same angle as multipule bottom plow bottoms are, in relation to tractor.
Follow Ups:
Home
| Forums
Today's Featured Article -
Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
