Farmall & IHC Tractors Discussion Board |
F-14 mag
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BC on November 06, 2002 at 16:36:50 from (206.74.216.159):
Is there any way that I can bencj test this thing other than spinning it over with my impact wrench.I can get spark across the safty gap but not to the plugs when its installed.Ive changed the coil with a known good one,Put in three known good condensors,pulled til my arm fell off onthe crank and pulled it around the feild til I ran out of gas in my other tractor and still nothing.I did notice that while we were pulling it,there was some light black smoke coming out of the exaust.I could move the spark advance or the throttle and maybe get a little hint of starting but still nothing.I could also do this,(I know its dangerous but)While pulling I reached up and choked it and I got alot more smoke out of it then closed the choke and nothing.I also shut off the gas and drained the carb.It would do the lite smoke until ,what I assume to be burning out hte rest of the gas in it,the soke would stop all together.We pulled it so miuch that gas was accually coning out of the the exaust pipe,not gushing out,but coming out,so thats is at least telling me Im getting gas.Any and all suggestions are very appreciaited!BC
Follow Ups:
Home
| Forums
Today's Featured Article -
Check Your Coolant - by Bill Radford. Great tips on how and when to check the coolant in your tractor.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|