|
Farmall & IHC Tractors Discussion Board |
Re: Re: putting a gas 350 motor in a farmall 350 diesel
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JIMBO on November 27, 2002 at 03:41:23 from (4.37.74.207):
In Reply to: Re: putting a gas 350 motor in a farmall 350 diesel posted by Joel on November 26, 2002 at 18:31:02:
Joel ,It's sure been an experience and an expensive lesson.The tractor is in excellent condition except for that motor.This summer it was running good with a little vibration after a 3000 dollar motor overhaul and one morning I tried to start it and the pump locked.I 've had that pump redone 3 times.Just maybe if I could get another pump it might be OK.I dont think those Continental engins were worth a damn.My I.H. dealer has one over there now torn down and doesn't know what to do with it.I'm fixing it up to show but don't know if I'm going to make it.
Follow Ups:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
