Re: Need help with i.d. of IH

Posted by Stan(VA). on December 18, 2002 at 05:22:22 from (208.59.157.95):

In Reply to: Need help with i.d. of IH posted by Rob on December 17, 2002 at 22:41:32:

Innnnput, we need innnput ;) (to borrow from the short circuit movies).

The cast in number sounds like a valid IH casting ID, the nelson tag must be something aftermarket added to the tractor. Look for a tag that says International Harvestor Corp. Typical places to look are attached to seat supports, left or right side of clutch housing, or near the pedal covers, or up front by the steering box and radiator support depending on which model you have and it's age.

Also, tell us a little about the tractor:
- wide front or narrow?
- engine in center of tractor or is it offset to the left?
- rear tire diameter? (24/36/38")
- are rear wheels bolted on flush to thge end of the axel, or a clamp arrangement that can slide on an axel shaft for different widths?
- does the steering wheel go down the top of the tractor and dissapear into the hood, or down the right side, or down the left side as it goes to the front?
Stan(VA).

Follow Ups:

• Re: Re: Need help with i.d. of IH Rob 18:51:07 12/23/02 (0)

Post A Followup Name: E-Mail: Subject: Re: Re: Need help with i.d. of IH Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]