Farmall & IHC Tractors Discussion Board |
Re: Now or Later?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Fred Kobs on January 15, 2003 at 01:16:35 from (207.177.45.89):
In Reply to: Now or Later? posted by Jason (SC) on January 14, 2003 at 22:31:14:
Hi Jason, Yes you should address the open holes Now. I would blow as much dirt as you can out of the holes with compressed air. Then the juice you use is entirely up to you but fill all 4 holes, I would use diesel fuel myself, and find sparkplugs that thread into the holes. Every month or so top off with more juice. The more you can prevent water from intruding the better. Do you have the exhaust and the intake sealed from the elements also?? If not, these need protection too. It will be much easier to work on later if you can get it sealed up somewhat. Good luck with the M Fred
Follow Ups:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|