|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Farmall H live hydraulics updates...
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Carp on January 25, 2003 at 05:23:31 from (209.240.23.112):
In Reply to: Re: Re: Farmall H live hydraulics updates... posted by Steven@nd on January 25, 2003 at 04:41:52:
Install the timing gears out of a later tractor (SH on up) and the timing gears will not be a problem. Install a pressure relief on the pressure side of the pump and stalling the pump will not be a problem. Run the starting tank into the top of the lift all and you get an additional 7/8 of a gallon of oil capacity. Use the liftall as a resivior for the live hyd like you said, but you still have the liftall. You might not have a use for the liftall today, but you might later. Seems to me that a 15 gpm pump on a 7/8" belt will fry the belt if you put a full pressure load against it. The belt would be just another maint item to upkeep. Plus the pump behind the ignition just looks a little cleaner.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Day Tractor Lovers Dream About - by Angus Crawford. The day started at five o'clock on the morning of Friday, the January 29, 1999. My father, my sister, my uncle, my cousin and myself all climbed into my uncle's Toyota van. It was six thirty in the morning and we had a long day ahead. We traveled for six and a half hours to our destination - a little country town with a population of no more then one hundred and fifty people (57 of them being children under the age of thirteen). We arrived hoping to meet up with a man we knew had over one
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
