farmall (a) fan shimming ?

Posted by Jon Mirgon on February 01, 2003 at 09:19:21 from (216.148.246.134):

I have recently rebuilt the engine on my (a) the biggest problem I had was getting the crankshaft pulley back on, it is a bout a half inch from being fully seated, but the front seal is making good contact with the seal, since the pulley is not all the way in, the belt alignment is off on the fan belt, I shimmed the fan assy out about an eighth of in inch to get it in line, has any one else done this, will it work ? or should I continue to beat on the crank pulley and get it in all the way ?\

Follow Ups:

• Re: farmall (a) fan shimming ? Bill Hires 10:24:31 02/01/03 (0)

Post A Followup Name: E-Mail: Subject: Re: farmall (a) fan shimming ? Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]