|
Farmall & IHC Tractors Discussion Board |
Starting an M for the first time after overhaul? Need help!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmall Daddy on March 16, 2003 at 17:55:13 from (209.183.116.152):
Got the starter to turn the motor over. Tried to pull start it today, and it started, ran for a couple of minutes, then croaked out when my dad tried to pull it out of a driveway in low gear. Pull started it again, ran same amount of time, then died. After it died the second time, it overheated, had a small leak on one hose, but fixed that. My dad adjusted the timing on it. Tried it again, nothing. Adjusted it again, ran for 30 seconds, then died. I adjusted it, ran for about 1 minute then choked out. What steps should I do to get her running long enough so I can set the valves? What does the book recommend the valves be set at. I have set the valves at 12 thousandths when cold, and then when it was heated up, but not running on both times. Any help on a list of steps will be greatly appreciated Thanks!!
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
