|
Farmall & IHC Tractors Discussion Board |
Re: Cub Cylinder -To Sleeve or not to sleeve, that is the question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BIG JOHN on March 23, 2003 at 19:35:43 from (64.12.97.13):
In Reply to: Cub Cylinder -To Sleeve or not to sleeve, that is the question posted by chaney creek on March 23, 2003 at 17:28:57:
The C-60 Cub engine does not have sleeves. If you can not hone out your imperfections then you will have to have the block rebored and oversize pistons installed. Most of us don't have the equipment or the expertise to do a rebore. This will bring a Machine Shop into the picture and the expense that accompanies their work for this job. You may want to look for a block that is in better condition than the one you have. GOOD LUCK
Follow Ups:
Home
| Forums
Today's Featured Article -
When Push Comes to Shove - by Dave Patterson. When I was a “kid” (still am to a deree) about two I guess, my parents couldn’t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He’s been run over by a train, he’s gone forever!" Where did they find me? Perched up on the seat of the tractor. I’d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this “green planet”. I’m par
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
