Farmall & IHC Tractors Discussion Board |
Re: Some tactics on getting a motor unstuck?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BIG JOHN on March 25, 2003 at 18:10:27 from (64.12.97.13):
In Reply to: Some tactics on getting a motor unstuck? posted by Farmall Daddy on March 25, 2003 at 17:37:24:
BEEN THERE -- DONE THAT!!!!!! There are so many things that can cause an engine to be stuck that there is no ONE set way to get an engine unstuck. One thing for sure I would not recomend pulling the tractor and popping the clutch. You will do way more damage than good. The first thing to do is tear into it and determine what the culprit is that caused it to be stuck. Since neither tractor is yours yet this is just about impossable. 1. Pull the plugs and check for water and rust. 2. Check the oil for water, metal and other foreign materials. 3. Pull the starter to make sure it is not the problem (jamed in the ring gear) 4. Ask the owner to see what he says is the problem. After you know these things someone here will probably be able to give you some good advise. My personal experience is that it is best to pull the head and the pan and then go from there. GOOD LUCK Super M's are great tractors.
Follow Ups:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|