|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Any quick advice on 300 utility
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by dick on March 26, 2003 at 18:58:59 from (64.156.34.131):
In Reply to: Re: Re: Any quick advice on 300 utility posted by Sean in Calgary on March 26, 2003 at 15:22:40:
You should be in pretty good shape compared to some of us with early 300U tractors. The Wheatland is supposed to have the heavy-duty, fixed axle on the front, compared with the adjustable on the 300U. IH also made the steering knuckles longer after #26457 in the 300U production run; those of us with lower serial numbers have to work harder, and probably are more likely to have steering problems. If you use a bit more care than you might have been before not to overload or stress the loader or steering, and make sure the steering reservoir stays full (generally the second-last thing to get checked, after the air cleaner), you should be OK.
Follow Ups:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
