Farmall & IHC Tractors Discussion Board |
Re: Re: SMTA Clutch
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ernie Bob on May 05, 2003 at 10:29:05 from (161.98.123.67):
In Reply to: Re: SMTA Clutch posted by Hugh MacKay on May 05, 2003 at 02:35:52:
Hugh, I talked with Pete in Bridgeport, a very knowledgable IH person, and what you said is exactly correct. He went one step further to tell me that because the spline will turn with the flywheel and by putting pressure with the bolts pulling the two togethr that I just continued to increase the pressure on the two and I bent the pressure plate. He said he learned this lesson the hard way many years ago, like I did last week. I'm going to pull the pressure plate off tonight and comnpare it to another one that I have and see if I can see the diference. Let Ya Know! Ernie Bob
Follow Ups:
Home
| Forums
Today's Featured Article -
The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|