Farmall & IHC Tractors Discussion Board |
Re: (A) HEADGASKET WOES, HELP !!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Travis on May 18, 2003 at 14:58:45 from (206.72.27.125):
In Reply to: (A) HEADGASKET WOES, HELP !! posted by JON MIRGON on May 17, 2003 at 16:24:50:
There has been one tractor I know of the correct torque wouldn't work, so a breaker bar was used and it is still running over 15 years later. This was on a 560, but that is most likely an isolated case. On an Oliver 1800 my Dad used to own we replaced the head gasket three times in a year and on the third time we actually painted the gasket with silver paint, let it get tacky and then installed it--never had problem again. We had even tried coppercoat and tabers hot gasket cement before that with no luck. I am a mechanic also and on any gasket like a "Printoseal" I won't use any sealer, but if its the old metal gaskets I almost always will use something.
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|