Farmall & IHC Tractors Discussion Board |
Re: Need advice on Farmall 200 steering problem
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on June 12, 2003 at 05:53:37 from (12.65.25.116):
In Reply to: Need advice on Farmall 200 steering problem posted by bradford253 on June 11, 2003 at 18:30:51:
The 200 is I think the same a C or Super C regards the steering gear. If you have had out the worm gear and the worm wheel (steering gear) and inspected the bearings, can't see what else would be wrong. If you replaced the big seal on bottom of the main steering shaft, you would have to have had the bearings out. However as you describe the problem, it sounds like one or both of the bearings that support the front end are bad. Also sounds like you have a wide front. Steering gear is the same as narrow front which I have. Don't know what effect the wide front would have.
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|