|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: hiLLs vs. narrow front end on farm
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JB on June 19, 2003 at 20:39:15 from (24.157.110.221):
In Reply to: Re: Re: Re: hiLLs vs. narrow front end on farmall posted by Hugh MacKay on June 19, 2003 at 19:35:58:
We had SC with both front ends. Changed to row crop for corn cultivating and hay mowing. Always used the wide front end when using the front end loader. One time during the summer a neighbor wanted some dirt moved with the loader and we had the narrow front end on. My Dad went over to move it and it was on a bit of a slope. To make a long story short, with the bucket full of dirt, the rear wheel on the down side of the slope dropped into a hole the rear wheel on the upper side came off the ground about a foot and just free wheeled until the bucket was lowered. Be careful with row crop front end and loader. JB
Follow Ups:
Home
| Forums
Today's Featured Article -
Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
Variable pulley for case 1530 skid loader
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
