Farmall & IHC Tractors Discussion Board |
Re: Filters for M (Oil , Air)
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by rustyfarmall on July 23, 2003 at 09:06:59 from (199.120.81.195):
In Reply to: Filters for M (Oil , Air) posted by Big Red on July 23, 2003 at 08:06:13:
Somebody mentioned in another post recently that a spin-on oil filter adaptor is available for H's. M's, etc. I think from your Case-I.H. dealer. I have had no experience with these, but you might want to check it out, although I don't know why you would want to, the original element type filters are readily available, and as long as you change the O-ring gasket each time you change the filter, you will not have any problems. As far as the air filter goes, it is an oil bath type filter, to my knowledge, there is no dry element that will replace it, unless you want to completely replace the entire unit and adapt something in its place. again, I don't know why you would want to, with proper maintenance, it will give you no trouble, and is more effective than a dry filter.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|