|
Farmall & IHC Tractors Discussion Board |
Re: Tips on changing points and condenser in IH di
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by howster mighty fine on August 05, 2003 at 18:35:15 from (65.172.143.109):
In Reply to: Tips on changing points and condenser in IH distri posted by Charlie on August 05, 2003 at 13:58:02:
sounds like a problen I had a few weeks ago. got a point set cheap when Farm and Fleet was going under. WRONG The condenser was just enough biger that I had one sam hill of a time getting the screw started. I'll not pull that dumb *ss trick again. Otherwise it is usually no tric to stat the screw. Most of my screwdrivers a magnetized just enough from use that a small screw will stay in the slot. Oh and by the way, I Always take those distributers off and work on them on the bench. Just put a little scratch on the side which way the roter is pointing.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Great Escape - by Dave Hollrah. It all began Monday with a little baling of second crop on the lake shore field, and as I drove out past my sister and her hubby's place, this small calling sound could be heard from the general direction of their manure pile. Out of the yard, over the cows and bale piles, through the dozer piles, poplars, and brush, out onto the ditch grade road, past the noisy 6.2 diesel engine pulling my well traveled Suburban along. Well it sure didn't take me long to figure out what it was because I alrea
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
