Farmall & IHC Tractors Discussion Board |
Re: Help with plow identification.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on September 01, 2003 at 04:36:42 from (216.208.58.99):
In Reply to: Help with plow identification. posted by Dave BN on August 31, 2003 at 17:53:28:
Dave: After viewing what gene had to say on this plow, I went back to my info in 150 Years Of IH. I gave you some wrong info yesterday without looking it up. I don't know that what I gave you changes much. The plow that was discontinued in 1942 was a Little Wonder No. 2. The Little Wonder No 3 was only introduced in 1940 and continued until 1955. He describes the No.3 as a single bottom plow built specificly for the Farmall A and B tractors, and it sold new for $75. plus $5. for a tail wheel. 15,000 of these were built. There were also Little Wonder 1 and 4 model numbers. The number 1 was built from 1921 to 1925 and from the way he describes it an operator must have raised it with the levers as he says no 2 was much improved with clutch lift. 2x14 only. The No. 4 also a 2 bottom was only called a No.4 Wonder plow. The no. 4 built from 1940 to 1948. If you look at 150 Years of IH you would wonder why IH used the designation Little Wonder and Little Genius as none of them had the same model numbers, and they were indeed all tractor plows. The other area I have noticed some discrepancies, is implements build by IH for Canadian market at the Hamilton Ontario works. Over the years I have noticed a few cases where US and Canadian copies of the same machine may have slightly different model designation. I think that manual cover picture I e mailed you is one case. It covers Canadian production at Hamilton. It calls the plow, obviously the same plow as a No.8 Little Genius, just a No.8 tractor plow. I also shows a single bottom No.8. Wendel in his book makes no mention of a single bottom No.8 Little Genius, nor does he mention the names Little Wonder and Little Genius being dropped during the 1940s. I cant think of specifics right now but over the years I've noticed other differences between Canadian and US buyers guide. I just wonder if anyone out there can enlighten us on this.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|