Re: Re: M lift-all oil check dipstick

Posted by ok here it is on September 03, 2003 at 10:42:54 from (65.172.143.39):

In Reply to: Re: M lift-all oil check dipstick posted by Nebraska Cowman on September 03, 2003 at 04:40:19:

I measured the dipstick. It is 10 inches long. Down from the top 7 inches is a mark that says "G. C. Full" I think this is to check the belt pulley gear case. Then 5 inches down from the top it is marked " HYDR. Full". Just use a piece of 5/23 welding rod (knock off the flux) to make one. Flatten the top end and run it through a washer with 5/32 hole. the flat spot will keep it from falling through the washer and the washer will keep it from falling down the pipe. That's how the factory ones are made.

Follow Ups:

• Re: Re: Re: M lift-all oil check dipstick Michael 11:12:46 09/03/03 (0)

Post A Followup Name: E-Mail: Subject: Re: Re: Re: M lift-all oil check dipstick Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]