Farmall & IHC Tractors Discussion Board |
finally got it going
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by super a wayne on September 26, 2003 at 16:29:37 from (24.82.10.43):
Hi all!, it's been a few years since i've been on this site, life has been very busy!, I finally got my 46 super a going( actually my wife's, she asked for something red with four wheels for her birthday)with a lot of help from my uncle. It turns out the mag was away out of timing as well as being weak. Now, the the problem I have is the mag sparks fine when turned by hand, but when the tractor is running i only get two leads firing, the leads are fine, and the cap and rotor are new, any ideas where I should look inside for possible problems?. Secondly, I just had the starter redone but it has a threaded battery cable post on it , as someone in the past had put a floor mounted switch on it, I have a new original type switch, can i file down the threaded post to mke a proper contact for the switch or do I have to get the starter shop to replace this post? what kind of post or stub do they originally have as i have never seen one up close. Getting ready to paint the remaining front half this weekend and hope to put her to work soon! thx
Follow Ups:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|