|
Farmall & IHC Tractors Discussion Board |
Re: Re: Farmall Steel wheels??????
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Wayne on September 29, 2003 at 19:39:11 from (66.38.33.129):
In Reply to: Re: Farmall Steel wheels?????? posted by CNKS on September 29, 2003 at 18:34:34:
I am assuming you are mostly concerned with the back wheels. We have almost always left the front on rubber on to eliminate jarring the radiators all to pieces. I have an H and my dad has several Farmall F-12's. I haven't actually put the F-12 steel wheels on the H but they measure the same axle diameter. I know an M has a larger diameter axle. To me the F-12 wheels seem quite narrow for the H. We have thought about using one complete F-12 steel wheel and an outer wheel (no center or spokes) and lugs bolted together to make it wide enough. Last time I checked F-12 steel rears were running about $150 per set and I seen a rear set for the H for $300. Should have got them... That's here in KY.
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
