Farmall & IHC Tractors Discussion Board |
Re: Re: Help: Rebuilt head / new valves, 1949' C
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by dan on November 26, 2003 at 05:48:18 from (66.140.105.107):
In Reply to: Re: Help: Rebuilt head / new valves, 1949' C posted by Randy in NE on November 26, 2003 at 04:23:32:
He about said it all but I got a couple suggestions. If you used aftermarket valve springs, guides or anything else check for coil bind or interferance at the top of the guide. I originaly got my parts at napa and I tell you I took it all back except the valve guides. None of it was right. I looked for myself in their book and it was right parts for the engine but they sure weren't right! Also I have used felpro headgaskets now on three c's and super c'c and all of them leaked till I went back and put on a IH head gasket.
Follow Ups:
Home
| Forums
Today's Featured Article -
Experimental Tractors Article - by Danny Bowes (Dsl). Tractor technology appears to have nearly hit it's pinnacle of development. If you agreed with the subtitle, you are rather mistaken. Quite, actually. As a matter of fact, some of the technology experimented with over 40 years ago makes today's tractor technology seem absolutely stale by comparison. Experimentation, from the most complex assembly to the most simple and mundane component, is as an integral a part of any farm tractor's development
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|