Re: smta engine overhaul

Posted by Dan on November 29, 2003 at 09:54:25 from (12.160.160.160):

In Reply to: smta engine overhaul posted by paul on November 28, 2003 at 19:04:02:

Pulled sleeves out of my SMTA several years ago. I cut out a steel circle small enough to go into hole in block but larger than outer sleeve diameter. I drilled a hole in the center and got some ready bolt that would screw into head bold holes, I used a steel piece between those ready bolts and a ready bolt down center with a nut on top and one on bottom of circle. by tightening nut on top you could pull sleeves without damage. Easier to build than to describe

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: smta engine overhaul Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]