Farmall & IHC Tractors Discussion Board |
Re: Farmall H and M transmissions
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by john d on January 28, 2004 at 19:40:33 from (152.163.252.227):
In Reply to: Farmall H and M transmissions posted by Rick in central MD on January 27, 2004 at 21:00:28:
In addition to the lack-of-maintenance situation, lots of them have been tinkered with to produce 1/3 or more additional power through overbore kits and high compression pistons. When the farmer got that much more power, he usually put it to work, and that meant pulling bigger loads than the engineers planned on. I've got a '49M that had the rear end completely rebuilt several years ago using 560 bearings everywhere they would fit. It withstood many years of hard use after that.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|