|
Farmall & IHC Tractors Discussion Board |
Re: 444 IHC Talk To Me?!British or Not
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BlueLite on February 10, 2004 at 20:03:25 from (206.172.124.23):
In Reply to: 444 IHC Talk To Me?!British or Not posted by Red on February 09, 2004 at 21:39:42:
I have a 434. Like everything about it 'cept
the contraption filled hydraulic unit. Loaded with
pivots,control arms,witchamacallits and a couple hundred 1/4in sized parts to make it all work. Any one of 'em ready to make the whole thing fail if not in sync,damaged or dirty. Right now I think I just found the problem with my lift. The draft spool popped it's "C" clip and
came out of it's cylinder. This allowed pressure to the regulator that causes the lift arms to go
full up with no response from the position control lever. If that's not the problem I figure it will be easier to isolate the piston and cylinder by threading and tapping screws in the escape orifices and simply buying a single spool to get me power up and fall down with no draft. (Implement draft gives a far superior furrow anyway). Only thing I recommend is keep your oil clean
and baby the 3pt else you'll be playing "find the
1/8in spring" on your shop floor.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I’m handing him tools and he says, "give me that..." and I’ve already got it in his hand or "hand me that....."and I’ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
