Farmall & IHC Tractors Discussion Board |
1066 won't start
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dan on February 21, 2004 at 19:05:30 from (205.188.209.82):
Put a cam and main bearings in our 1066. Got it back together today and can't get it to fire without ether. Cracked the injector lines and getting diesel to all injectors. Injector pump gear got unmeshed with the idler when we pulled the front cover off. So I am suspecting I am out of time. However, when I put the engine at 18 on the flywheel to check the timing of the pump, the pointer and mark are almost right on. Off by less than the width of the pointer. Since the pointer on the flywheel has a slight bit of play to it, you can get the pointer and mark on the pump, to match up with the pointer and 18 on the flywheel. How exact is the timing? Is that the culprit, or do you guys have any other ideas? Thanks. By the way, as was pointed out earlier, I am not an IH mechanic, but would gladly take the advice of one, shade tree or otherwise.
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|