Farmall & IHC Tractors Discussion Board |
Re: Re: Would 15W40 be too heavy for my H??
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on February 23, 2004 at 07:32:32 from (165.170.128.66):
In Reply to: Re: Would 15W40 be too heavy for my H?? posted by Don on February 22, 2004 at 20:47:56:
Don - The car makers spec 5W20 spec instead of a heavier oil primarily for fuel mileage - it gains 'em a few tenths of a mpg in EPA certification testing. Beyond that there's no reason heavier 10W30, 15W40, etc are not acceptable. At the farm where I occasionally pitch in, the local oil jobber has installed a 200 gallon bulk tank in shop and keeps it filled with 15W40. For many years the oil has been used in EVERYTHING on the farm with an engine: 855 Cummins turbodiesels in the big tractors; older 4020 gas & diesels; antique Deere, IHC and MM tractors; the owner's wife's Buick; even her lawnmower. About the motors that don't get 15W40 are the 2 stroke motors in the chainsaws and snowmobiles.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Great Escape - by Dave Hollrah. It all began Monday with a little baling of second crop on the lake shore field, and as I drove out past my sister and her hubby's place, this small calling sound could be heard from the general direction of their manure pile. Out of the yard, over the cows and bale piles, through the dozer piles, poplars, and brush, out onto the ditch grade road, past the noisy 6.2 diesel engine pulling my well traveled Suburban along. Well it sure didn't take me long to figure out what it was because I alrea
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|