Farmall & IHC Tractors Discussion Board |
Re: Make Run or Paint First?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Paul in Mich on February 24, 2004 at 07:13:20 from (68.188.227.110):
In Reply to: Make Run or Paint First? posted by Tony on February 24, 2004 at 05:50:29:
Tony, The easy and short answer to your question is get it running first. Having said that, there are some parts that you may find to be easier to paint while disassembled, or at least give a prime coat. Most people I've talked to and I included shoot at least one coat of primer, and 3 coats of finish paint to complete the rebuild. While it is true that your first priority is to get the tractor running good before painting, your second priority will probably be to stop all the leaks by replacing seals and gaskets. As you go through this processs, you will discover that there are nooks and crannies that make it very difficult to paint when assembled. In that case, you can prime or even go so far as to prime and paint first finish coat before assembling that particular segment. Chances are that you will end up painting places that didn't get painted at the factory because of their inaccessability. After you get all the mechanical work done including seals and gaskets, you will find that you will disassemble some parts to make it easier to clean up and paint. Thats when you will want to have everything primed, and then complete a first coat of finish paint on everything. Next you'll probably want to assemble everything but sheet metal, and give a second finish coat, then assemble all the sheet metal and give a third and final finish coat with everything fully assembled. The exceptions to this are those items which are to be painted a different color, which you will add after the painting is complete or masked in the process. Essentially, you wnat to have everything in good operating order before you paint, but as you see, restoring is a total, ongoing process, not necessarily one in defined segments.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|