Re: 450 is hard to get out of gears

Posted by Michael Soldan on February 26, 2004 at 17:50:28 from (216.46.130.44):

In Reply to: 450 is hard to get out of gears posted by old on February 26, 2004 at 17:02:06:

Old, I was using a tractor that had clutch problems and there were two things that were syptomatic, one the gears always ground a little when you shifted into gear and two, the shifter lever never allowed the gears to disengage and you had to pull hard to pull it out of gear. I'm guessing that if your tractor has been sitting for some time a few good runs may help then I would check the finger adjustments , then the actual clutch adjustment, but from what you said I'm guessing clutch . The shifter could be rusted inside or the pins on which the gears slide but that is less likely than clutch....good luck, from Mike in Exeter Ontario

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: 450 is hard to get out of gears Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]