Farmall & IHC Tractors Discussion Board |
Re: Re: Super M input shaft bearing
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by mike on March 06, 2004 at 17:48:11 from (24.231.183.114):
In Reply to: Re: Super M input shaft bearing posted by paul on March 06, 2004 at 16:21:18:
I'm working on the input shaft assembly to the main transmission. The input shaft is in it's own housing which bolts into the main case. The front bearing of the old bearing had a groove on the OD. I believe that the groove was to hold an outside snapring which would position the input shaft. The input shaft bearing retainer is designed for a snapring on the OD of the bearing. The bearing which I purchased from Gruenwald in Wisconsin does not have the groove on the OD of the bearing. Do you have any information which shows a snapring to position the input shaft in the front bearing housing assembly. If you do could you please let me know how I could get a copy or any more information. Thanks, Mike
Follow Ups:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|