Farmall & IHC Tractors Discussion Board |
Re: Any one lifting round bales with a H and trip
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on March 16, 2004 at 03:16:19 from (209.226.247.78):
In Reply to: Any one lifting round bales with a H and trip load posted by Kelly C on March 15, 2004 at 18:54:57:
Kelly: I wouldn't worry about the Hs ability to lift the round bales. As for the safety concerns Paul and Michael are raising, where people are getting in trouble with this is on Utility type tractors and the fact you are sitting low and much closer to pivot point of loader. When that bale comes down those loader arms on a Utility you technically are right at the bottom of the incline. These accidents are not happening with bale spear, but rather with pallet type forks with out a built up back on the loader bucket. They should also have a frame work over the operator just in case. My real concern is the same as Andy, without the hydraulic controll on loader bucket. you will find yourself uttering a lot of 4 letter words when the angle of the spear just isn' right. You want the 400 free for baling duty, the H will make a fine rake tractor. Why not put the loader on the 300, as either one of those loaders you have will fit the 300, plus live hydraulics and the second valve for hydraulic bucket control. Widen the 300 out to about 80" centers on rear tires and make up a concrete ballast about 7 to 10 cubic feet, that can be mounted on drawbar. I have forgotten whether you 300 has fast hitch, if so fast hitch forks can be cast right in the concrete block. Makes a great ballast that you can put on or remove quickly with little effort. I handled a few 5x6 round bales with my 300, piece of cake for 300. Just build something so if a bale comes down it cant get you.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I’m handing him tools and he says, "give me that..." and I’ve already got it in his hand or "hand me that....."and I’ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|