|
Farmall & IHC Tractors Discussion Board |
Re: 3 pt hitch plow
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on April 01, 2004 at 02:28:40 from (216.208.58.164):
In Reply to: 3 pt hitch plow posted by Bart on April 01, 2004 at 01:25:25:
Bart: You indicated just plowing a few gardens. For that purpose I would tend to go with the 2x16 plow. I have never had any experience with Saginaw hitches, but one must remember you don't have a draft controled 3 point hitch. Without draft control I doubt if you would be very happy if you were doing a lot of plowing. For that reason I would stay with the 2x16, M will lug that along iregardless of draft. Gardens in residential areas tend not to have the best drainage, room for turning often a factor. For those reasons plus you may as well only maintain two bottoms as three. If you ever decide to do a lot of plowing, get yourself a 3x16 or 3x14 trailer.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
