|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: What is it?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gary_N_WV on May 11, 2004 at 18:04:32 from (69.43.20.80):
In Reply to: Re: Re: What is it? posted by Jay on May 10, 2004 at 19:04:02:
Jay,
If I understand what you are saying.....from your clutch pedal there is a rod that goes back and hooks to a lever.
This lever is on the ouside, then a round shaft goes though a bored hole(bearing surface) and on the other side is the lever that works the cluch linkage.
This lever on the opposite side from where the linkage from the peddle hooks, has the bolt and jam nut.
All the bolt and jam nut does is hold the lever on the shaft and also indexes it to the right place.
When you say it is cone shaped, do you mean it is cone shaped on the end that goes inside the lever? Am I correct in my thinking ?
Gary
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
