Farmall & IHC Tractors Discussion Board |
Re: Re: Two Questions, Weight?/How to transport F
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jamie Stratton on June 02, 2004 at 19:01:28 from (24.154.170.211):
In Reply to: Re: Two Questions, Weight?/How to transport Farma posted by Dave_Id on June 02, 2004 at 09:32:21:
When I hulled my farmall M from washington pa to cecil county md it was convenient. My dad is a truck driver. We got the tractor on to a roll back then drove it off the roll back onto his 45 foot flat bed. The 6000 lb or so tractor didn't even flex the trailer. Of course I'm talking about a 17000 pound freighliner not a ford f-150. I think it would be dangerous, but depends on the trailer. If you have a double or triple axle trailer with a good enough weight rating it should work. Most new trucks today can only pull 10000 pounds though so it may be hard.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|