Farmall & IHC Tractors Discussion Board |
Re: 450D Pops
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by captaink on July 07, 2004 at 08:16:43 from (66.115.212.249):
In Reply to: 450D Pops posted by Andy Martin on July 06, 2004 at 14:49:27:
If after warm up it is a steady “pop” in the exhaust (like every time the cylinder fires) I suspect that the exhaust valve gap is too tight. As the engine warms, the valve stem increases in length and the gap shrinks, possibly to nothing and then the vavle won't seal correctly. I would check the valve clearance (needs to be done with the engine up to operating temp) fist and make sure it is up to spec. If this isn’t the problem, you probably have an exhaust valve or seat that is going bad and as you mentioned is only showing up after compression comes up when the engine is warm. Good luck!
Follow Ups:
Home
| Forums
Today's Featured Article -
Check Your Coolant - by Bill Radford. Great tips on how and when to check the coolant in your tractor.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|