Farmall & IHC Tractors Discussion Board |
Re: I'll settle for...
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steve W (NY) on August 31, 2004 at 09:32:52 from (24.213.210.222):
In Reply to: I'll settle for... posted by ffolkes on August 31, 2004 at 09:18:10:
If I remember correctly, the post has a collar or something tht pushes up against the notched plate. The notched plate goes up against the steering post. On the other side of the steering post is a locknut and nut over the threaded part. To the left of the plate is the lever, and then a spring, and then a washer, and then a cotter pin to hold it on. The idea is that the spring holds it into the notches. I hope this helps. If not I'll take a picture. Take Care Steve
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|