Farmall & IHC Tractors Discussion Board |
Re: Is this a C?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by terryj on September 28, 2004 at 00:19:31 from (216.209.122.182):
In Reply to: Re: Is this a C? posted by SAm in NS on September 27, 2004 at 09:59:38:
Yes there is a 2 inch gap between the gas tank and hydraulic unit. The peddals have a slight curve. Not sure if disk or drum brakes the covers are about 3 inches deep if that is of any clue. Not sure what a waterpump would look like on a C but it does have somekind of pump on the left by the generator that is run by a belt. I am going to have to really clean that little raised flat took some paint thinner to it to remove the rust but still can't see any numbers.
Follow Ups:
Home
| Forums
Today's Featured Article -
Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|